Access the entire Evaluation Kit Quik-Start User's Guide in PDF format.

General Description. The SMM605EVAL kit is a fully functional printed circuit board designed to demonstrate all the features of the SMM605 Nonvolatile, Programmable Six-Channel Supply Voltage Marginer and Active DC Output Controller (ADOC™). The SMM605EV operates from either a +5V or a +12V supply and includes six nonisolated DC-DC converters. A precision voltage reference permits the DC-DC converters to be trimmed to within a ±0.2% tolerance. [continued in the PDF]

SMM605EV User's Guide Table of Contents: Operating Instructions (Pg. 3) Performance Measurements (Pg. 4, 5, 6, 7) SMM605EV Schematic (Pg.8) Layout Drawings, Jumper functions (Pg. 9, 10) Bill of Materials (vendor sources) (Pg. 11, 12) Large PCB ground plane minimizes voltage errors Comments & Precautions (Pg. 12) Dongle pin-out & photo (Pg. 13) Figure 1: SMM605 Evaluation Board	Several key, user-configurable functions are: 1. Programmable nominal, high and low trim/margin voltages. 2. Programmable input/output assertion polarities. 3. Programmable converter TRIM pin polarity. 4. Programmable Fast/Slow ADOC/Margin times. 5. Programmable on-board regulator (3.6V or 5.5V). Additional features included on the EVAL board: EZ connect Power and Signal pins User-Programmable Interface connector to digitally control power supply voltages, fault checking, etc. 6 Low-Profile, Non-Isolated DC-DC converters with Trim/Enable/Sense Functions 48-pin TQFP Spring-Loaded Socket for SMM605 Status Indicators (LED) included for power, fault, etc. Large PCB ground plane minimizes voltage errors Evaluation Kit Contents 1. Fully Functional SMM605 Evaluation Board. 2. SMM605 Evaluation Kit User's Guide 3. Dongle Programmer Interface Card. 4. Dongle to I2C Interface Cable (1 meter). 5. CD-ROM containing: SMM605EV Gerber Files, GUI Software, Hex file, Application Notes/Briefs.
Contact your sales rep to order an eval kit. U.S. and Canadian Reps | International Reps

 

SUMMIT Microelectronics, Inc. reserves the right to make changes to the products contained in this publication in order to improve design, performance or reliability. SUMMIT Microelectronics, Inc. assumes no responsibility for the use of any circuits described herein, conveys no license under any patent or other right, and makes no representation that the circuits are free of patent infringement. Charts and schedules contained herein reflect representative operating parameters, and may vary depending upon a user's specific application. While the information in this publication has been carefully checked, SUMMIT Microelectronics, Inc. shall not be liable for any damages arising as a result of any error or omission.

SUMMIT Microelectronics, Inc. does not recommend the use of any of its products in life support or aviation applications where the failure or malfunction of the product can reasonably be expected to cause any failure of either system or to significantly affect their safety or effectiveness. Products are not authorized for use in such applications unless SUMMIT Microelectronics, Inc. receives written assurances, to its satisfaction, that: (a) the risk of injury or damage has been minimized; (b) the user assumes all such risks; and (c) potential liability of SUMMIT Microelectronics, Inc. is adequately protected under the circumstances.

Revision A - This document supersedes all previous versions.

ADOC™is a trademark of Summit Microelectronics, Inc.
I2C is a trademark of Philips Corporation.