1  2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Next -->

SMM105 Single-Channel Supply Voltage Marginer and Active DC Output Controller Windows GUI Users Guide and Configuration Register Descriptions

PAGE 15

Register R44 - COMP1 and COMP2 Fault Status Register (Volatile and Non-Volatile) This register shows the Fault Status for the COMP1 and COMP2 UV/OV monitor functions. The Fault Status indication information is accomplished by reading bits D0 through D3. The Fault status can be Read with the "Read" button and cleared with the "Clear" button if the Fault is removed.

Figure 16 - Register R44 ADOC Windows GUI Tab, a check mark in the square indicates a Fault.

1  2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Next -->

SUMMIT Microelectronics, Inc. reserves the right to make changes to the products contained in this publication in order to improve design, performance or reliability. SUMMIT Microelectronics, Inc. assumes no responsibility for the use of any circuits described herein, conveys no license under any patent or other right, and makes no representation that the circuits are free of patent infringement. Charts and schedules contained herein reflect representative operating parameters, and may vary depending upon a user's specific application. While the information in this publication has been carefully checked, SUMMIT Microelectronics, Inc. shall not be liable for any damages arising as a result of any error or omission. SUMMIT Microelectronics, Inc. does not recommend the use of any of its products in life support or aviation applications where the failure or malfunction of the product can reasonably be expected to cause any failure of either system or to significantly affect their safety or effectiveness. Products are not authorized for use in such applications unless SUMMIT Microelectronics, Inc. receives written assurances, to its satisfaction, that: (a) the risk of injury or damage has been minimized; (b) the user assumes all such risks; and (c) potential liability of SUMMIT Microelectronics, Inc. is adequately protected under the circumstances. Revision 1.1 - This document supersedes all previous. Please check the Summit Microelectronics, Inc. web site at www.summitmicro.com for updates. I2C is a trademark of Philips Corporation.

Copyright © 2003 SUMMIT MICROELECTRONICS, Inc. Power Management for Communications™