1  2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Next -->

SMM105 Single-Channel Supply Voltage Marginer and Active DC Output Controller Windows GUI Users Guide and Configuration Register Descriptions

PAGE 14

Register R43 - STATUS TRACKING CODE Identification - Read Only Identifying the "STATUS TRACKING CODE" of the SMM105 is accomplished by reading register 43, D0 through D7. The command is also available in the Configuration pull down menu. After the GUI determines the code, only the programming options available for that code are shown in the Windows GUI. An additional Session Log Window will appear with further information regarding the Status Tracking Code. The status code will only appear if an actual device is read by the GUI, otherwise it will be 00.

Figure 15 - Register R43 ADOC Windows GUI Tab

1  2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Next -->

SUMMIT Microelectronics, Inc. reserves the right to make changes to the products contained in this publication in order to improve design, performance or reliability. SUMMIT Microelectronics, Inc. assumes no responsibility for the use of any circuits described herein, conveys no license under any patent or other right, and makes no representation that the circuits are free of patent infringement. Charts and schedules contained herein reflect representative operating parameters, and may vary depending upon a user's specific application. While the information in this publication has been carefully checked, SUMMIT Microelectronics, Inc. shall not be liable for any damages arising as a result of any error or omission. SUMMIT Microelectronics, Inc. does not recommend the use of any of its products in life support or aviation applications where the failure or malfunction of the product can reasonably be expected to cause any failure of either system or to significantly affect their safety or effectiveness. Products are not authorized for use in such applications unless SUMMIT Microelectronics, Inc. receives written assurances, to its satisfaction, that: (a) the risk of injury or damage has been minimized; (b) the user assumes all such risks; and (c) potential liability of SUMMIT Microelectronics, Inc. is adequately protected under the circumstances. Revision 1.1 - This document supersedes all previous. Please check the Summit Microelectronics, Inc. web site at www.summitmicro.com for updates. I2C is a trademark of Philips Corporation.

Copyright © 2003 SUMMIT MICROELECTRONICS, Inc. Power Management for Communications™