Summit Microelectronics, Inc: Developer Support

Summit Microelectronics, Inc

Tech Support: Applications Note 38
SMM105 Single-Channel Supply Voltage Marginer and Active DC Output Controller
Windows GUI Users Guide and Configuration Register Descriptions



The layout of the HTML version of the application note follows the page breaks in the PDF version. To navigate, you may click on a page number (below) to jump to another other page. You may also download/view the entire application note in PDF format [PDF format].

1 

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

Next -->

SMM105 Single-Channel Supply Voltage Marginer and Active DC Output Controller
Windows GUI Users Guide and Configuration Register Descriptions

  PAGE 6    


Register R05 - Programmable Slave Address
Bits D[3:0] of this register allows the configuration of the I2C slave address. Bits D[7:4] are unused and should be set to 0. The slave address can be programmed to any four bit number, 0000BIN through 1111BIN

 
 

Figure 9 - Register R05 ADOC GUI Tab, the "Perform Address Search" can find the Slave address automatically which includes both the Slave Address and Pins A2, A1 and A0 Address bits combined. In order to change the Slave Address, the "Perform Address Search" box must be cleared.

1 

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

Next -->


SUMMIT Microelectronics, Inc. reserves the right to make changes to the products contained in this publication in order to improve design, performance or reliability. SUMMIT Microelectronics, Inc. assumes no responsibility for the use of any circuits described herein, conveys no license under any patent or other right, and makes no representation that the circuits are free of patent infringement. Charts and schedules contained herein reflect representative operating parameters, and may vary depending upon a user's specific application. While the information in this publication has been carefully checked, SUMMIT Microelectronics, Inc. shall not be liable for any damages arising as a result of any error or omission.

SUMMIT Microelectronics, Inc. does not recommend the use of any of its products in life support or aviation applications where the failure or malfunction of the product can reasonably be expected to cause any failure of either system or to significantly affect their safety or effectiveness. Products are not authorized for use in such applications unless SUMMIT Microelectronics, Inc. receives written assurances, to its satisfaction, that: (a) the risk of injury or damage has been minimized; (b) the user assumes all such risks; and (c) potential liability of SUMMIT Microelectronics, Inc. is adequately protected under the circumstances.

Revision 1.1 - This document supersedes all previous. Please check the Summit Microelectronics, Inc. web site at
www.summitmicro.com for updates.

I2C is a trademark of Philips Corporation.

 

Summit Microelectronics Home Page

Summit Development Support


Copyright © 2003 SUMMIT MICROELECTRONICS, Inc.
Power Management for Communications™