Summit Microelectronics - Applications Note 28

Tech Support: Applications Note 28
SMT4214 Expandable Four-Rail Supply TRAKKER™ Controller, Windows GUI and Configuration Register Descriptions

Application Note 28

1 2 3 4 5 6 7 8 9 10

SPECIAL NOTE: The HTML version of the application note has been divided into multiple pages to mimic the PDF version. You may use the menu here or at the bottom of the page to jump to any of the other pages. You may also download/view the entire application note in PDF format [PDF format].

WINDOWS GUI USERS GUIDE AND CONFIGURATION REGISTER DESCRIPTIONS

PAGE 8

Register R06 - Indicates device status (volatile). Registers 06 is an volatile indicator register that provides feedback on device status. However, bit D7 is a Read/Write bit that when read is an indicator of device state. When a write to D7 is performed, it used to power the device on/off through the I2C bus.

Summit Application Note 28-Table 04.gif

WINDOWS GUI USERS GUIDE AND CONFIGURATION REGISTER DESCRIPTIONS

PAGE 9

Figure 10 - Register R06 Windows GUI Tab. Pressing the I2C Power On/Off buttons will write to Register 05, bit D7.

Application Note 28

1 2 3 4 5 6 7 8 9 10

NOTICE

SUMMIT Microelectronics, Inc. reserves the right to make changes to the products contained in this publication in order to improve design, performance or reliability. SUMMIT Microelectronics, Inc. assumes no responsibility for the use of any circuits described herein, conveys no license under any patent or other right, and makes no representation that the circuits are free of patent infringement. Charts and schedules contained herein reflect representative operating parameters, and may vary depending upon a user's specific application. While the information in this publication has been carefully checked, SUMMIT Microelectronics, Inc. shall not be liable for any damages arising as a result of any error or omission.

SUMMIT Microelectronics, Inc. does not recommend the use of any of its products in life support or aviation applications where the failure or malfunction of the product can reasonably be expected to cause any failure of either system or to significantly affect their safety or effectiveness. Products are not authorized for use in such applications unless SUMMIT Microelectronics, Inc. receives written assurances, to its satisfaction, that: (a) the risk of injury or damage has been minimized; (b) the user assumes all such risks; and (c) potential liability of SUMMIT Microelectronics, Inc. is adequately protected under the circumstances.

Revision 1.0 - This document supersedes all previous versions and covers Status Tracking Codes up to 01 and Windows GUI revision 2.3.0 and later. Please check the Summit Microelectronics, Inc. web site at www.summitmicro.com for data sheet updates.

return to top

home

technical support