|
|
|
|
Designing
a NEBS-compliant Power System -
SMH4804
|
|
|
|
|
|
|
|
High-voltages,
as used in NEBS
compliance testing, are
extremely hazardous and
can be lethal. Do not
proceed with testing
until all possible
safety measures are
taken. Be certain to
wear eye protection and
never perform testing
alone.
|
|
|
|
|
Pre-Testing for NEBS Compliance
The
UCS500 waveform generator applies waveforms to the
DUT. Figure 2 displays the menu various test
waveforms available from the UCS500 Selecting the
'Burst' waveform (F1, IEC 61000-4-4) generates a
series of identical pulses with programmable
amplitude, waveform shape, etc.
The UCS500 displays the selections as shown in
Figure 3. Selecting the EN50082-1 (F5) test routine
prepares the UCS500 to output the Burst Waveform.
The Graphical Interface Window is used to set the
test waveform characteristics, test duration and
time interval between the pulse bursts (Figure
4).
|
Figure
2. UCS500 Front Panel 'MAIN MENU'
display
|
|
|
|
Figure 3: UCS500 Front Panel 'Burst Standard Test
Routines' display.
|
|
|
|
|
|
|
SUMMIT
Microelectronics, Inc. reserves the right
to make changes to the products contained
in this publication in order to improve
design, performance or reliability. SUMMIT
Microelectronics, Inc. assumes no
responsibility for the use of any circuits
described herein, conveys no license under
any patent or other right, and makes no
representation that the circuits are free
of patent infringement. Charts and
schedules contained herein reflect
representative operating parameters, and
may vary depending upon a user's specific
application. While the information in this
publication has been carefully checked,
SUMMIT Microelectronics, Inc. shall not be
liable for any damages arising as a result
of any error or omission.
SUMMIT Microelectronics, Inc. does not
recommend the use of any of its products
in life support or aviation applications
where the failure or malfunction of the
product can reasonably be expected to
cause any failure of either system or to
significantly affect their safety or
effectiveness. Products are not authorized
for use in such applications unless SUMMIT
Microelectronics, Inc. receives written
assurances, to its satisfaction, that: (a)
the risk of injury or damage has been
minimized; (b) the user assumes all such
risks; and (c) potential liability of
SUMMIT Microelectronics, Inc. is
adequately protected under the
circumstances.
Revision 1.1 - This document supersedes
all previous versions and covers Status
Tracking Codes up to 10 and Windows GUI
revision 2.39.3 and later. Please check
the Summit Microelectronics, Inc. web site
at www.summitmicro.com
for data sheet updates.
|
|
Copyright
© 2003 SUMMIT MICROELECTRONICS, Inc.
Power Management for Communications™
|
|
