SMR101 Programmable Reset Controller

FEATURES Two Programmable Reset Outputs, SOFT_RST# And HARD_RST# De-Bounced Push-Button Reset Input With a Programmable Delay Up To 40 Seconds Prior To Reset Assertion 8 Programmable Settings For Both SOFT_RST# And HARD_RST# Delay Programmable Voltage Monitor With 8 VoltageSettings To Trigger SOFT_RST# Output Programmable Reset Output Duration From 1-200ms Built-In 15us Voltage Glitch Filtering And Input "De-Bouncing" 6 Ball Ultra CSP™ (Chip-Scale) Package 8 Lead SOIC Package

APPLICATIONS PDAs, Handheld PCs, Cameras, Camcorders Handheld GPS Equipment Satellite And Cable-TV Set-Top Box

INTRODUCTION The SMR101 is a programmable reset controller especially designed for embedded consumer electronics. The device provides dual outputs that can be used to implement "soft" and "hard" system resets. Both resets can be triggered by an external reset input, and an internal voltage monitor can trigger the soft reset. Typically a "soft" reset applies to volatile registers in an embedded controller while a hard reset is equivalent to a full power cycle without the associated power-up delays. The SMR101 receives an external push-button input using an internal programmable debounced timer. The push button input hold down time is programmable up to 40 seconds with an internal on-chip timer. A "short" hold down time (0.125-10 sec) asserts the SOFT_RST# pin while a long hold down time (0.5-40 sec) asserts the HARD_RST# pin. Both reset outputs have programmable output durations from 1- 200ms. Additionally, voltage monitoring is provided via a programmable threshold detector (2.30V - 4.50V) on the VDD pin. This voltage detector asserts the SOFT_RST# pin for the same 1-200ms output duration as above. A 15us glitch filter avoids nuisance tripping that can result in unnecessary system resets. The SMR101 is factory programmed, to default values; however, multiplexed programming pins are also provided for in-system programming for prototype purposes. [continued in the SMR101 datasheet PDF] SMR101 ORDERING INFORMATION The default device ordering number is SMR101E-316 and is programmed as described in the DC/AC Operating Characteristics tables on page 5 and 6 and tested over the commercial temperature range